Immobilizer and Transponder
indication for correct immobilizer programming.
Checking for correct immobilizer programming
Insert the red key in the ignition switch. Set it to ON. The led (1) on the instrument panel will flash
(see further below for details of LED indications). And then led (1) turns off.
First flashing indication
:
-
if the led flashes for two seconds, it means that the immobilizer is not programmed, maybe because
the programming procedure has not been strictly followed. Repeat the programming procedure from
the start.
- if the led flashes for 0.7 seconds, it means that the immobilizer is correctly programmed
Second flashing indication
:
-
a series of short flashes indicates the number of programmed keys. If programming has been
successfully completed, the led must flash three times (a red key and two black keys used for
programming)
Third flashing indication
(possible immobilizer system faults):
- the immobilizer is trouble-free if the led (1) is off
- a flash indicates a communication error between the decoder in the instrument panel and engine
control unit via serial line ISO 9141/5
- two flashes indicate a failure of the inserted key, the antenna on the ignition switch or both
- three flashes indicate that the inserted key has not been acknowledged by the system
- four flashes indicate that the engine control unit is programmed but the decoder in the instrument
panel is not programmed
If one of the above cases under "third flashing indication" occurs, the engine cannot be started.
Emergency procedure to override the immobilizer system
If the immobilizer is faulty, follow the emergency procedure below to start the engine.
1 turn the ignition key to ON, fully open the throttle twistgrip and keep it open; the EOBD light (2)
that turned on, turns off after 8 seconds.
2 release the throttle twistgrip once the EOBD light has turned off
3
Now enter the electronic code indicated on the CODE CARD which is given to the customer on
motorcycle delivery by the dealer.
the EOBD light starts flashing.
count a number of EOBD light flashes which is as the first digit of the electronic code. Completely
turn the throttle twistgrip and hold it open. The EOBD light stays fixed on for four seconds: it
means that the first digit of the emergency code has been acknowledged.
If the throttle twistgrip is untouched, the EOBD light will flash 20 times, then it will stay
permanently on. In this case the whole procedure should be repeated from step 1.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_8_9_00.85.1.html (5 of 9) [10/7/2008 8:47:22 PM]