Throttle control
–
choke
Check that the choke control lever is in the rest position.
Insert the new control cable (2) in the frame. Observe the original routing.
Tighten the adjuster (11) into the throttle body support.
Thread the core cable (2) through the linkage hole, the spring (7) and the throttle body pawl.
Pull the end of the core cable to keep the cable taut and tighten the pawl screw (F).
Loosen the check nut and work the adjuster (11) so as to allow some play in the sheath.
Rotate the lever fully down and make sure that the small lever (H) of the throttle body contacts the end stop (L). If
not so, slacken the screw (F) and release the core cable (2).
Repeat the process until the small lever (H) is touching the end stop (L).
Turn the handlebar right and left and make sure the small lever (H) is not moving. Otherwise, turn the adjuster (11).
Tighten the check nut into the adjuster (11) when finished.
Note
Refer to the figures on the next pages for the correct routing of the choke cable.
Choke/throttle cables routing
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_F_1_6_00.25.1.html (6 of 8) [10/7/2008 8:43:19 PM]