Steering
Fit steering shaft into steering tube and push until it becomes fully seated axially.
Install the bottom yoke assembly to the frame.
Grease the ball ring (B) and fit it to the top outer ring (
C
) of the frame.
Fit the inner ring (A) of the upper bearing (
5
) onto the steering shaft; its larger side should be face up.
Fit the oil seal (4) with the flat face facing upwards.
Grease the ring nut (3).
Screw the ring nut (3) finger-tight until it contacts the oil seal (4).
Position the special bush no.
88713.1058
onto the ring nut (3) and then fit the torque wrench on the bush.
Tighten the adjusting ring nut (3) to the specified torque (Sect. C 3,
).
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_H_2_7_00.42.1.html (7 of 8) [10/7/2008 8:44:15 PM]