![background image](http://html1.mh-extra.com/html/ducati/monster-695/monster-695_user-manual_2537677601.webp)
Indicators and lighting system
Checking the right switch
Undo the screws (1) and disconnect the right switch from the electric system to remove it.
Colours mentioned in the descriptions refer to the colour of wires from the switch and not to the colour
of wires of the main electric system.
Engine stop button
Check for continuity between
(Red/Black and Red/White)
cables with a multimeter (Sect. P 9 on
multimeter operation). When the button is in
run
mode, electric continuity should be available
between the two cables. When the button is in
off
mode, no electric continuity should be available
between the two cables.
If the above does not apply, the
engine stop
switch is defective and should be replaced. Colours
mentioned in the descriptions refer to the colour of wires from the switch and not to the colour of wires
of the main electric system.
Starter button
Proceed as described for the engine stop button and check for continuity between
(Blue/White and
Black)
cables when
starter
button is pressed (see Sect. P 9,
on multimeter operation). If the
above does not apply, the
starter
button is defective and should be replaced. Colours mentioned in
the descriptions refer to the colour of wires from the switch and not to the colour of wires of the main
electric system.
Parking light/low beam switch
Using the same multimeter (Sect. P 9,
, on multimeter operation), check the continuity across
the following cables:
(Red/Yellow)
cables for the low beam.
The light switch should operate as follows:
Connect the multimeter to
(Red/Yellow)
cables, then position the switch to low beam mode and
continuity between the two cables should be available. If the above does not apply, the light switch
should be replaced.
Fit the right switch, tighten the screws (1) to the specified torque (Sect. C 3,
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_5_9_00.82.1.html (3 of 8) [10/7/2008 8:47:09 PM]