![background image](http://html1.mh-extra.com/html/ducati/monster-695/monster-695_user-manual_2537677092.webp)
Testers
Ensure that throttles are against the stop screw (throttle twistgrip fully closed). Ensure choke is off and that throttle
cable free play is correct. Reset the TPS as indicated in "
Zero setting the throttle position sensor (TPS)
section.
Check
:
- that throttle angle reading on DDS is 2.7° ± 0.1° with engine stopped;
-
that idle condition is acknowledged; if not, repeat the procedure indicated in "
Zero setting the throttle position
".
Open the by-pass screws (21) by one turn, from fully closed position.
Start the engine and allow oil to reach 75° C; switch off choke, if previously activated.
When oil temperature is above 75° C you can start the following adjustment procedure; always bear in mind that at
the end of the adjustment oil temperature should not exceed 100° C.
Idling should be between 1250±1350 rpm (1300±50)
If the value is included in the above range, check the CO level and ensure that values are min. 0.5 and max 0.9 for
both cylinders. If CO reading is lower or higher than indicated range, open or close by ¼ of a turn the by-pass screw
(21) of the cylinder having incorrect reading and allow 20 seconds before checking again with the gas analyser.
If idling speed is not within the above-indicated range, open or close by ¼ of a turn the by-pass screws (21) of both
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_D_5_5_00.19.1.html (17 of 41) [10/7/2008 8:43:05 PM]