Casing unit: crankcases
Lever drum and note dial gauge reading. This will be total axial play. Determine the amount of shimming required to
obtain a final end float between
0.10
and
0.40
mm.
Divide total play by two to determine the amount of shimming required on each side of the selector drum.
Note
Final end float should be closer to
0.40
rather than
0.10
mm.
Separate the casings and insert the necessary shims on each side of the selector drum.
To shim the gearbox primary shaft (G), begin with a shim (L) of the same size used for the selector drum.
Fit the primary shaft to the clutch-side (right) casing with the shim.
Install the fork (F) and its pin (P).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (15 of 25) [10/7/2008 8:46:35 PM]