![background image](http://html1.mh-extra.com/html/ducati/monster-695/monster-695_user-manual_2537677524.webp)
Casing unit: crankcases
Check that the selector drum is in NEUTRAL, looking at the clutch-side end.
Now hold the primary shaft in position and check that the clutch dogs of the sliding gear are equally distant from the
dogs of the fixed gears. This is done by inserting a feeler gauge (S) between the dogs.
Note
Press the sliding gear in both directions so as to take up play.
If the dogs are not equally distant from the other clutch dogs, change the primary shaft shim (L).
Fit a
2.5-
mm shim (H) to the secondary shaft.
Fit the secondary shaft to the clutch-side (right) casing. Install the two forks with their pins.
Select a shim of adequate size following the same procedure as for the primary shaft.
Determine the amount of shimming for the left end (generator side) to obtain nearly
zero
end float when the casing
is closed.
Place a small shim (
1.5
mm) on primary shaft and no shims on the secondary shaft.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (16 of 25) [10/7/2008 8:46:35 PM]