Rear brake control
Remove the system component parts as shown in the exploded view at the beginning of this section.
Warning
After servicing the rear brake control, check the brake pedal position following the instructions given in Sect. D 4,
Adjusting the position of the gear change and rear brake pedals
Refitting the rear brake master cylinder
Lubricate the O-ring (B) and fit it to the pin (5).
Lubricate the other O-ring (B).
Refit the pin (5) to the brake pedal lever (9), insert the spring (6), the other O-ring (B) and the washer (12).
Apply threadlocker to the thread of the pin (5).
Install the footpeg plate to the frame (Sect. H 4,
).
Installation is a reversal of the removal procedure.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_F_4_6_00.28.1.html (4 of 6) [10/7/2008 8:43:28 PM]