INSTALLATION TO VTX 1800 C
1.
Ensure that the motorcycle is on flat level ground.
2.
It is recommended that the motorcycle sit for at least one
hour prior to installation to allow the engine to cool.
3.
Remove the three radiator mounting bollts and allow the
radiator to hang from the hoses (10mm Socket).
Install Frame Bracket
4.
From the front, place the “U” Bolt on the frame down
tube near the top of the engine.
Figure 1. Loosely
install
Frame Bracket with Flat Washers and Whizlock Nuts (1/2”
Wrench.)
Orient assembly so Whizlock Nuts face engine.
Do not tighten.
Figure 2.
By National Cycle
INSTALLATION AND OWNER’S MANUAL
P4009
for HONDA® VTX1800 C
NOTE:
Right and Left side of Motorcycle is determined
while sitting on the bike.
PARTS LIST
Index
Part No.
Description
Qty.
1
90-970100-000
Highway Bar, Left
1
2
90-970101-000
Highway Bar, Right
1
BAG 380
3
51-515720-000
Screw, M8 x 20
4
4
51-513105-000
Screw, M10-1.25 x 105
3
5
37-371590-000
Frame Bracket
2
6
51-513050-000
“U” Bolt
2
7
42-431010-000
Whizlock Nut, Chrome
4
8
49-490311-200
Washer, Flat
4
Ball End Hex Key, 6mm
Hex Key, 8mm
10mm and 14mm Socket
Wrench 14mm
Wrench, 1/2”
Handle with 3/8” Drive
Torque Wrench
Service Manual
4
2
5
7
1
6
3
8
Page1 of 2
10-114850-000
04/03
Figure 2
Parts List
Figure 1
6
8
7
Note: to facilitate installation of the Whizlock Nuts to the “U” Bolt,
loosely pre-assemble the Frame Bracket to the “U” Bolt with
threaded ends of “U” facing outward.
Once your frame
bracket is loosely
assembled, rotate
bracket so whizlock
nuts face engine.
