DX380LC-7
Opening Window
1.
Lower bucket or work tool to ground.
2.
Move safety lever to "LOCK" position.
3.
Set engine speed control dial to "LOW IDLE". Allow engine
to idle for three - five minutes.
4.
Stop engine by turning key to "O" (OFF) position.
5.
Hold window handles (1, Figure 181), then pull lock levers
(2, Figure 181) to release lock. The top of front window will
come out.
6.
Pull window up, and push it against lock pin at the rear of
cabin. Make sure that it is securely latched.
7.
Check that lock levers are securely latched in locked position.
NOTE:
When front upper window is open, never extend
your head or body through window frame.
NOTE:
If window happens to fall against machine, while
some part of your body is extended outside
cabin, it can result in serious personal injury.
NOTE:
The front window is spring loaded to aid in
opening it. To fasten rear lock pin, hold handle
and fasten rear lock pin.
Closing Window
1.
Lower bucket or work tool to ground.
2.
Move safety lever to "LOCK" position, and stop engine.
3.
Holding upper handles (1, Figure 182) of front window with
left and right-hand, pull lock levers (2, Figure 182) to
release lock.
4.
Push window forward, and lower it slowly.
5.
When bottom of window, reaches top of the front bottom
window, push front window to engage lock (2, Figure 182).
6.
Check that lock levers are securely latched in lock position.
DS1901105
1
2
Figure 181
WARNING
AVOID DEATH OR SERIOUS INJURY
When storing front window in cabin roof, make sure both
lock levers (2, Figure 181) are securely latched.
DS1901106
1
2
Figure 182
WARNING
AVOID DEATH OR SERIOUS INJURY
Keep hands away from window frame when opening or
closing window.
