DX380LC-7
8.
The unit does not require disassembly for normal
over-the-road transportation. If the boom and arm need to
be removed, the counterweight will place more weight on
the rear of the machine. Make sure to back the excavator
onto the trailer so the counterweight end (heavy end) of the
excavator is positioned on the ramp first. See Figure 10.
9.
Extend bucket and arm cylinders to maximum length and
then lower the boom slowly.
10. Move safety lever to "LOCK" position.
11. Stop engine by turning key to "O" (OFF) position.
12. Remove key from starter switch.
13. Turn battery disconnect switch to "OFF" position.
14. Lock all doors and covers.
15. Adjust direction of rotating beacon and TMS antenna.
16. Make sure to secure the excavator onto the trailer before
transporting. Place blocking (1, Figure 12) in front of and
behind each track. Tie front and rear (2, Figure 13) and tie
down point (3, Figure 13) on the lower frame with wire
cable as required by local transportation regulations.
17. Refer to "Specification" section of this manual for overall
machine height and width dimensions. Make sure to
position the excavator as shown. If not transported in this
position, the height measurements may be different.
EX1300747
15
Figure 10
EX1300748
Figure 11
EX1300749
1
1
2
Figure 12
