DX380LC-7
Safety
1-52
During Storage
•
Once a month, start the engine and follow the "Hydraulic
Oil Warm-up" procedures listed in this manual.
•
Operate hydraulic functions for traveling, swing and
digging two or three times for lubrication after "Hydraulic
Oil Warm-up". Coat all the moving parts and surfaces of
the components with a new oil film after operating. At the
same time, charge the battery. Rotate track to prevent
track seizing".
•
Every 90 days, use a hydrometer to measure the
protection of the coolant. Refer to the antifreeze/coolant
protection chart to determine protection of the cooling
system. Add coolant as required.
After Storage
•
Before operating the work equipment, remove all grease
from the hydraulic cylinder rods.
•
Add grease and oil at all lubrication points.
•
Adjust fan and alternator belt tension.
•
Connect the charged battery.
•
Check condition of all hoses and connections.
•
Check the levels of engine oil, fuel, coolant and hydraulic
circuit oil. If there is water in the oil, change all the oil.
•
Change all filters.
•
Inspect for signs of nests. (i.e. birds, rodents, etc.)
•
When starting the engine after long-term storage, follow
the "Hydraulic Oil Warm-up" procedures listed in this
manual.
