DX380LC-7
Safety
1-28
Protecting Cabin from Flying or Falling Objects
(If Equipped)
In a work site where additional operator protection is necessary
from falling or flying objects, install adequate protective guards
on the cabin.
For breaker operation, install a front guard (1, Figure 20) and
apply a laminated coating sheet to front glass. Contact your
DOOSAN distributor for recommendations.
When performing demolition or cutting operation, install a front
guard and top guard.
When working in mines, quarries or other work sites where there
is a hazard of falling rocks, install Operator Protection Guard
(OPG) (2, Figure 21).
When OPG is installed, and front window needs to be cleaned,
loosen bolts marked with arrows (Figure 21). Be sure to tighten
bolts when done.
Never attempt to alter or modify any protective structure
reinforcement system, by drilling holes, welding, remounting or
relocating fasteners. Any serious impact or damage to system
requires a complete inspection of the structure. Reinstallation,
recertification and/or replacement of system may be necessary.
Contact your DOOSAN distributor for available safety guards
and/or recommendations to protect against objects that could
strike operator's cabin. Make sure that all other work site crew
members are kept away from excavator when operating.
If any glass on machine is broken, replace it with new glass
immediately.
NOTE:
The preceding instructions assume that conditions
are for standard operations, but it may be necessary
to add additional guards depending on operating
conditions or local rules or regulations for the work
site. Always contact your DOOSAN distributor for
advice.
1
DS1901184
Figure 20
DS1901185
2
Figure 21
