DX380LC-7
Inspection, Maintenance and Adjustment
4-40
A.
Arm link joint pin (1 point)
B.
Link joint pin (2 points)
C.
Arm bucket joint pin (1 point)
D.
Bucket link joint pin (1 point)
E.
Bucket cylinder rod pin (1 point)
Swing Bearing - Lubricate
1.
Park machine on firm and level ground. Lower the front
attachment to the ground and stop engine.
2.
There are three grease fittings for the swing bearing. Do
not over lubricate. Purge old grease with new. Remove all
purged grease.
Fuel Tank Water and Sediment - Drain
1.
Perform this procedure before operating the machine.
2.
Drain water and sediment from bottom of fuel tank into an
approved container.
NOTE:
Dispose of drained fluids in compliance with all
applicable environmental laws and regulations.
NOTE:
Always completely fill fuel tank at end of each
workday to prevent condensation from forming
on the inside walls of the tank.
DS1900852
C
A
B
D
E
Figure 32
DS1900853
Figure 33
DS1603056
Figure 34
