1592015820 User manual IC260_261L_D DUO FW1.9 rel. 1.0
Pag. 47 of 149
If the proportional output Pou1 - Pou2 - Pou3 - Pou4 are configured to drive an external relay the display will show 0=relay off
and 100=relay on.
Read-out of the time counting to the next defrost
The 2 times delay to next defrosts of the two circuits can be showed in the menu function.
dF FUNCTION
time to next defrost.
Label involved in dF function:
dF1
delay time to next defrost of the circuit 1
dF2
delay time to next defrost of the circuit 2
The labels apperas on if the heat pump configuration is enabled.
Enter the function menu :
1. Use the UP or DOWN keys to select
dF
2. Push
SET
key: the dF1 label is showed on the top display, the bottom display shows the time delay to
next defrost in minutes / seconds. The
icon is on.
3. Use the UP or DOWN keys to select dF1 or dF2.
4. To exit the Hour function push MENU key or wait the timeout
Read-out of the probes configured to control Solar panel
Sol FUNCTION
Label involved in
Sol
function
:
FCP1
Free cooling probe 1 temperature
FCP2
Free cooling probe 2 temperature
FCdF
Free cooling
differential
FCrL
Free cooling water pump status
FCAn
Free cooling analog output status
Read-out of the probes configured to control Free cooling
Sol FUNCTION
Label involved in
Sol
function
:
SLPb
Solar panel probe 1 temperature
SSP2
Solar panel probe 2 temperature
SSdi
Solar panel differential
SPMP
Solar panel water pump status
SLrL
Solar panel valve status
Read-out of the probes configured to control an auxiliary output relay
The probe values, configured to control the auxiliary relay output, can be showed in the menu function.
uS FUNCTION
temperature/pressure value of the control probe for auxiliary output.
Label involved in
uS
function
:
uSt1
auxiliary probe value of the circuit 1
uSt2
auxiliary probe value of the circuit 2
Enter the function menu
1. Use the UP or DOWN keys to select uS.
2. Push
SET
key: the label
uSt1
(temperature probe ) or
uSP1
(Pressure probe) is showed on bottom
display, the top display shows the the temperature or pressure value.
3. Use the UP or DOWN keys to select
uSt1
auxiliary probe for circuit 1or
uSt2
auxiliary probe for circuit 2.
4. To exit the Hour function push MENU key or wait the timeout.
How to display the tempaerature of the internal temperaure sensor of the remote terminals 1
or 2
Inside the funcion menu it is possible to see the ambient temperature detected by the NTC sensor
FUNCTION trEM
to show the temperature of the remote panels
Identification label
trEM.
trE1
value of the NTC probe of the remote #1
trE2
value of the NTC probe of the remote #2
Select with
UP
or
DOWN
the
trEM
function
Push
SET
the trE1 or trE2 label is shown on the bottom display, the top display shows the probe value.
Use the UP or DOWN arrow to change beteween
trE1
or
trE2
read-out.
