Delta VFD-ED Series, User Manual

Page: 376 / 389

Appendix B. Revision History

VFD-ED
B-3
Major Changes
Description Chapter
 The table for screw specification for optional card terminal is deleted and screw
specifications are respectively placed into the right bottom corner for each PG
card figure.
 The number of PG cards for Vertical View of the Motor Drive & Screw
Specifications are corrected from two to three: EMED-PGABD-1,
EMED-PGHSD-1 and EMED-PGHSD-2.
 Applicable encoders for EMED-PGHSD-1 and EMED-PGHSD-2 updated
 EMED-PGABD-1\Terminal TB2\Terminals A/O and B/O\
SW2 is corrected to SW3 in Descriptions column
 EMED-PGHSD-2 (Terminal TB2) pin definitions depend on the encoder type
\Terminals\
Change terminal order in the terminal table to match that in the terminal figure,
and information of the second row is deleted. “Must set Pr.10-31=1” to terminals
C+ and C- for Heidenhain ERN1387 is added.
 Terminal UP is corrected into Up.
 Terminal Vp is corrected into VP.
 Terminal DVin is corrected into Vin.
Chapter 7
 General Specifications\brake torque updated
 General Specifications\certifications updated
 Operation temperature updated
Chapter 8
 Menu items under MENU key for KPC-CC01 keypad functions are corrected to
13 items and unsupported item 4, 5 and 7 are noted.
 Unsupported menu items under Section 9-4 Digital Keypad KPC-CC01 Functions
are corrected from two items (4 and 5) to three items (4, 5 and 7).
 Language selections for Language Setup are corrected to three languages:
English, Traditional Chinese and Simplified Chinese and that only these three
languages are currently supported are noted.
 Subsection 3) Edit Main Page is deleted because the contents are the same as
those in subsection 2) Edit Main Page & Example of Download under Section 9-6
TPEditor Installation.
Chapter 9
 Flow chart for the auto-tuning process updated
 Explanations for the auto-tuning steps updated:
Step 1: Pr.00-02, Pr.00-14, Pr.00-15, Pr.02-01–02-08, Pr.02-15–02-16 settings
Step 2: Encoder Settings
Step 3: Pr.00-09 and Pr.01-02 settings,
【
PM Motor
】
\Motor Auto-tuning\ Pr.08-00
NOTE1 descriptions, and Pr.08-00 NOTE2 descriptions under Measure the Angle
between the Magnetic Pole and the PG Origin.
Step 4: Pr.01-12–01-19 NOTE description, and analog setting
Step 7: Pr.11-00, Pr.11-06–11-08 settings, (3) Start-up adjustment (FOCPM),
Chapter 10