Dell PowerVault MD3060e Series, Cli Manual

Page: 197 / 226

• Ethernet port
• Physical disk interface
Syntax
show (allControllers | controller [(0 | 1)]) [summary]
Parameters
Parameter Description
allControllers
Returns information about both RAID controller modules in
the storage array.
controller
Returns information about a specific RAID controller
module in the storage array. Valid RAID controller module
identifier values are 0 and 1. The identifier value is 0 for
the RAID controller module on the top and 1 for the RAID
controller module on the bottom when viewed from the
rear of the enclosure. You must put brackets ([ ]) around
the RAID controller module identifier.
summary
Returns a concise list of information about both RAID
controller modules in the storage array.
Show RAID Controller Module NVSRAM
This command returns a list of the NVSRAM byte values for the specified host type. If you do not enter the optional
parameters, this command returns a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)]) NVSRAM [hostType=(
hostTypeIndexLabel | host=" hostName ")]
Parameters
Parameter Description
allControllers Returns information about both RAID controller modules in
the storage array.
controller Returns information about a specific RAID controller
module in the storage array. Valid RAID controller module
identifier values are
0
and
1
. The identifier value is
0
for
the RAID controller module on the top and
1
for the RAID
controller module on the bottom when viewed from the
rear of the enclosure. You must put brackets ([ ]) around
the RAID controller module identifier.
hostType Specifies the index label or number of the host type. Use
the
show storageArray hostTypeTable
command to generate a list of available host type
identifiers.
host Specifies the name of the host connected to the RAID
controller modules. You must put quotation marks (" ")
around the host name.
197