Dell PowerVault MD3060e Series, Cli Manual

Page: 120 / 226

Parameter Description
the RAID controller module firmware determines the
owner.
mapping This parameter enables you to map the virtual disk to a
host. If you want to map later, set this parameter to
none
.
If you want to map the virtual disk now, set this parameter
to
default
, and the virtual disk is mapped to all hosts
that have access to the storage pool.
The default option is
none
.
warningThreshold Valid values are from
1
to
100
.
The default value is determined by the RAID controller
module firmware.
Setting this parameter to
100
disables warning alerts.
repositoryExpansionPolicy Valid values are
automatic
and
manual
.
cacheReadPrefetch The setting to turn on or turn off cache read prefetch. To
turn off cache read prefetch, set this parameter to
FALSE
. To turn on cache read prefetch, set this
parameter to
TRUE
.
segmentSize Amount of data (in kilobytes) that the RAID controller
module writes on a single physical disk in a virtual disk
before writing data on the next physical disk. Valid values
are
8
,
16
,
32
,
64
,
128
,
256
, or
512
. For information
about the
segmentSize
parameter, see Using the Auto
Configure Command.
usageHint Valid values are
multiMedia
,
database
or
fileSystem
.
Create Remote Replication
NOTE: This command is valid only with Fibre Channel storage arrays.
This command creates both the primary virtual disk and the secondary virtual disk for a remote replication pair. This
command also sets the write mode (Synchronous or Asynchronous) and the synchronization priority.
Syntax
create remoteReplication primary=
” primaryVirtualDiskName ”
secondary=” secondaryVirtualDiskName ”
(remoteStorageArrayName=” storageArrayName ” |
remoteStorageArrayWwn=” wwID ”)
[remotePassword=” password ”
syncPriority=(highest | high | medium | low |
lowest)
autoResync=(enabled | disabled)
writeOrder=(preserved | notPreserved)
writeMode=(synchronous | asynchronous)]
Parameters
120