Dell PowerVault MD3060e Series, Cli Manual

Page: 160 / 226

Parameter Description
the LUN mapping, set this parameter to
FALSE
. The
default value is
FALSE
.
NOTE: When you use this command, you can specify any combination of the parameters for global setting, virtual
disk configuration setting, host topology, or LUN mapping. To enter all settings, use the
allConfig
parameter.
The parameters are optional; you do not have to enter any parameters.
Save Storage Array Events
This command saves events from the Major Event Log (MEL) to a file.
Any or all of the following events can be saved:
• Critical events—Errors occurring on the storage array that needs to be addressed immediately. Loss of data
access may occur if the error is not immediately corrected.
• Warning events—- Errors occurring on the storage array resulting in degraded performance or reduced ability
to recover from additional errors. Access to data has not been lost, but the must be corrected to prevent
possible loss of data access in the event of an additional error.
• Informational events—Events occurring on the storage array that do not impact normal operations. This event is
reporting a change in configuration or other information useful in evaluating the performance of the storage
array.
• Debug events—Events occurring on the storage array that provides information useful in determining steps or
states that led to the error. This information may be useful to your Technical Support representative in helping
determine error causes.
NOTE: Some storage arrays may be unable to support all the above mentioned types of events.
Syntax
save storageArray (allEvents | criticalEvents warningEvents
| infoEvents | debugEvents)
file=" filename " [count= numberOfEvents
forceSave=(TRUE | FALSE)]
Parameters
Parameter Description
allEvents
Saves all events to a file.
criticalEvents
Saves only critical events to a file.
warningEvents
Saves only warning events to a file.
infoEvents
Saves only informational events to a file.
debugEvents
Saves only debug events to a file.
file
Specifies name of the file to which to save the events. You
must put quotation marks (" ") around the file name.
count
Specifies the number of events or critical events to save
to a file. If you do not enter a value for the count, all events
or critical events are saved to the file. If you enter a value
for the count, only that number of events or critical events
160