Dell PowerVault MD3060e Series, Cli Manual

Page: 30 / 226

Recurring Syntax Syntax Values
IPV6HopLimit 0 to 255 (default value is 64)
IPV6NdDetectDuplicateAddress 0 to 256
IPV6NdReachableTime 0 to 65535 (default value is 30000 milliseconds)
IPV6RetransmitTime 0 to 65535 (default value is 1000 milliseconds)
IPV6NDTimeOut 0 to 65535 (default value is 3000 milliseconds)
maxFramePayload 1500
NOTE: The maxFramePayload parameter is shared
between IPv4 and IPv6. The payload portion of a
standard Ethernet frame is set at 1500 bytes, and a
jumbo Ethernet frame is set at 9000 bytes. When using
jumbo frames, make sure that all of the devices
contained in the network path can handle the larger
frame size.
tcpListeningPort (tcp-port-id) 3260, or 49,152 to 65,536
The default value is 3260.
Usage Guidelines
The following list provides guidelines for writing script commands on the command line:
• You must end all commands with a semicolon (;).
• You can enter more than one command on a line, but you must separate each command with a semicolon (;).
• You must separate each base command and its associated primary and secondary parameters with a space.
• The script engine is case sensitive.
• You can add comments to your scripts to make it easier for you and future users to understand the purpose of
the script commands. (For information on how to add comments, see Adding Comments To A Script File).
NOTE: While the CLI and script commands are not case sensitive, user labels (such as for virtual disk, hosts, or
host ports) are case sensitive. If you try to map to an object identified by a user label, you must enter the user label
exactly as it is defined, or the CLI and script commands fails.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
NOTE: The capacity parameter returns an error if you specify a value greater than or equal to 10 without a space
separating the numeric value and its unit of measure. (For example,
10 GB
returns an error, but
10 GB
does not
return an error).
Adding Comments To A Script File
You can add comments to a script file in three ways:
• The script engine interprets as a comment any text typed after two forward slashes (/ /) until an end
‑
of
‑
line
character is reached. If the script engine does not find an end
‑
of
‑
line character in the script after processing a
30