Dell PowerVault MD3060e Series, Cli Manual

Page: 157 / 226

Parameter Description
diskGroup
Number of the disk group to be set to the optimal state.
You must put brackets ([ ]) around the disk group number.
Revive Disk Pool
This command forces a disk pool and its associated physical disks to the Optimal state.
CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the disk
pool. Do not try to revive a disk pool unless you are supervised by your Technical Support representative.
Syntax
revive diskPool [ diskPoolName ]
Parameter
Parameter Description
diskPool The alphanumeric identifier (including - and _) of the disk
pool that you want to revive. Enclose the
diskPoolName
in
square brackets ([ ]).
Revive Physical Disk
This command forces the specified physical disk to the optimal state.
CAUTION: Correct use of this command depends on the data configuration on all physical disks in the disk group.
Never attempt to revive a physical disk unless supervised by a Technical Support representative.
Syntax
revive physicalDisk [enclosureID,slotID ]
Parameter
Parameter Description
physicalDisk Identifies the enclosure and slot where, the physical disk
resides. Enclosure ID values are
0
to
99
. Slot ID values
are
0
to
31
. You must put brackets ([ ]) around the
enclosure ID value and the slot ID value.
Save Enclosure Log Data
This command saves the enclosure log sense data to a file. Log sense data is maintained by the environmental cards for
each enclosure. Not all of the environmental cards contain log sense data.
Syntax
save allEnclosures logFile=" filename "
Parameter
157