Dell PowerVault MD3060e Series, Cli Manual

Page: 171 / 226

Parameter Description
hostChannel The identifier number of the host channel for which you
want to set the loop ID.
The host channel identifier number is constructed by
combining the controller number and the host channel
number. Enclose the host channel identifier number in
square brackets ([ ]). Separate the controller number from
the host channel number with a comma.
For example, the identifier number for host channel 2 on
controller 0 would be [0,2].
preferredID The port identifier for the specified host port. Port ID
values are
0
to
127
.
Set Host Group
This command renames a host group.
Syntax
set hostGroup [ hostGroupName ]
userLabel=" newHostGroupName "
Parameters
Parameter Description
hostGroup
Name of the host group to rename. You must put brackets
([ ]) around the host group name. If the host group name
has special characters, you must also put quotation marks
(" ") around the host group name.
userLabel
New name for the host group. You must put quotation
marks (" ") around the host group name.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
This command changes the host type for an HBA host port. You can also change an HBA host port label with this
command.
Syntax
set hostPort [ portLabel ] host=“ hostName ”
userLabel=“ newPortLabel ”
Parameters
Parameter Description
hostPort The name of the HBA host port for which you want to
change the host type, or for which you want to create a
new name. Enclose the HBA host port name in square
brackets ([ ]). If the HBA host port label has special
171