Dell PowerVault MD3060e Series, Cli Manual

Page: 215 / 226

NOTE: This command is for IPv4 only.
Syntax
start storageArray isnsServerRefresh
Parameter
None.
NOTE: If you used the
set storageArray isnsIPv4ConfigurationMethod
command to set the
configuration but did not set the configuration to DHCP, running the
start storageArray
isnsServerRefresh
returns an error.
Start Virtual Disk Initialization
This command starts the formatting of a virtual disk in a storage array.
NOTE: Initializing a virtual disk is a long-running operation that you cannot stop.
Syntax
start virtualDisk [ virtualDiskName ] initialize
Parameter
Parameter Description
virtualDisk
Name of the virtual disk for which to start the formatting.
You must put brackets ([ ]) around the virtual disk name. If
the virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual disk name.
Stop Configuration Database Diagnostic
This command stops the diagnostic test to validate the configuration database in the controller firmware that was
started by the
start storageArray configDbDiagnostic
command.
Syntax
Stop storageArray configDbDiagnostic
Parameters
None.
NOTE: The controller firmware returns a confirmation that the diagnostic test was cancelled. In addition, the
database configuration diagnostic test can be started through the storage management software GUI but cannot
be stopped through the storage management software GUI. If you want to stop a running diagnostic test, you must
use the
stop storageArray configDbDiagnostic
command.
Stop Disk Group Blink
This command turns off the indicator LED on the physical disk that was turned on by the
start diskGroup blink
command.
Syntax
stop diskGroup blink
Parameters
215