Dell PowerVault MD3060e Series, Cli Manual

Page: 153 / 226

• An unassigned physical disk
• A fully integrated hot spare physical disk
Syntax
replace physicalDisk ([ enclosureID,slotID ] | < wwID >)
replacementPhysicalDisk= enclosureID,slotID
Parameters
Parameter Description
physicalDisk Specifies the physical disks to assign to the virtual disk
that you want to create. Specify the enclosure ID and slot
ID for each physical disk that you assign to the virtual disk.
Enclosure ID values are
0
to
99
. Slot ID values are
0
to
31
. You must put brackets ([ ]) around the enclosure ID
value and the slot ID value.
physicalDisk <wwID> The World Wide Identifier (WWID) of the physical disk
that you want to replace. You can use the WWID instead
of the virtual disk name to identify the virtual disk. Enclose
the WWID in angle brackets (< >).
replacementPhysicalDisk Specifies the physical disks to assign to the virtual disk
that you want to create. Specify the enclosure ID and slot
ID for each physical disk that you assign to the virtual disk.
Enclosure ID values are
0
to
99
. Slot ID values are
0
to
31
.
Reset RAID Controller Module
This command resets a RAID controller module.
NOTE: When you reset a RAID controller module, the RAID controller module is not available for I/O operations
until the reset is complete. If a host is using virtual disks owned by the RAID controller module being reset, the I/O
directed to the RAID controller module is rejected. Before resetting the RAID controller module, either verify that
the virtual disks owned by the RAID controller module are not in use or ensure a multipath driver is installed on all
hosts using these virtual disks.
Syntax
reset controller [(0 | 1)]
Parameter
Parameter Description
controller RAID controller module to reset. Valid RAID controller
module identifier values are
0
and
1
. The identifier value
is
0
for the RAID controller module on the top and
1
for
the RAID controller module on the bottom when viewed
from the rear of the enclosure. You must put brackets ([ ])
around the RAID controller module identifier. If you do not
specify an owner, the RAID controller module firmware
returns a syntax error.
153