Dell PowerVault MD3060e Series, Cli Manual

Page: 187 / 226

Whenever a security-enabled physical disk is powered on, it requires the correct security key from the RAID controller
module before it can read or write data. So, a security-enabled physical disk uses two keys: the physical disk key that
encrypts and decrypts the data and the security key that authorizes the encryption and decryption processes. The
set
storageArray securityKey
command commits the security key to all of the RAID controller modules and
security-enabled physical disks in the storage array. The self-encrypting disk feature ensures that if a security-enabled
physical disk is physically removed from a storage array, its data cannot be read by any other device unless the security
key is known.
Set Storage Array Time
This command sets the clocks on both RAID controller modules in a storage array by synchronizing the RAID controller
module clocks with the clock of the host from which you run this command.
Syntax
set storageArray time
Parameters
None.
Set Storage Array Unnamed Discovery Session
This command enables the storage array to participate in unnamed discovery sessions.
Syntax
set storageArray unnamedDiscoverySession=(TRUE | FALSE)
Parameter
Parameter Description
unnamedDiscoverySession This parameter turns on or turns off unnamed discovery
sessions. Set the parameter to
TRUE
to turn on unnamed
discovery sessions. Set the parameter to
FALSE
to turn
off unnamed discovery sessions.
NOTE: Discovery is the process where initiators determine the targets that are available. Discovery occurs at
power-on/initialization and also if the bus topology changes, for example, if an extra device is added.
NOTE: An unnamed discovery session is a discovery session that is established without specifying a target ID in
the login request. For unnamed discovery sessions, neither the target ID nor the target portal group ID are
available to the targets.
Set Virtual Disk
This command defines the properties for a virtual disk. You can use most of the parameters to define properties for one
or more virtual disks, however, some of the parameters define properties for only one virtual disk at a time. The syntax
definitions are separated to show which parameters apply to several virtual disks and which apply to only one virtual
disk. The syntax for virtual disk mapping is listed separately.
Syntax Applicable to One or More Virtual Disks
set (allVirtualDisks | virtualDisk
[“ virtualDiskName ”] |
virtualDisks [“ virtualDiskName1” ...
“virtualDiskNameN ”] |
187