Dell PowerVault MD3060e Series, Cli Manual

Page: 189 / 226

Parameter Description
mediaScanEnabled The setting to turn on or turn off media scan for the virtual
disk. To turn on media scan, set this parameter to
TRUE
.
To turn off media scan, set this parameter to
FALSE
. (If
media scan is disabled at the storage array level, this
parameter has no effect.)
mirrorCacheEnabled The setting to turn on or turn off the mirror cache. To turn
on the mirror cache, set this parameter to
TRUE
. To turn
off the mirror cache, set this parameter to
FALSE
.
modificationPriority The priority for virtual disk modifications while the storage
array is operational. Valid values are
highest
,
high
,
medium
,
low
, or
lowest
.
owner The RAID controller module that owns the virtual disk.
Valid RAID controller module identifiers are 0 or 1, where,
0 is the RAID controller module in slot 0, and 1 is the RAID
controller module in slot 1. Use this parameter only if you
want to change the virtual disk owner.
readCacheEnabled The setting to turn on or turn off the read cache. To turn
on the read cache, set this parameter to
TRUE
. To turn off
the read cache, set this parameter to
FALSE
.
writeCacheEnabled The setting to turn on or turn off the write cache. To turn
on the write cache, set this parameter to
TRUE
. To turn off
the write cache, set this parameter to
FALSE
.
cacheReadPrefetch The setting to turn on or turn off cache read prefetch. To
turn off cache read prefetch, set this parameter to
FALSE
. To turn on cache read prefetch, set this
parameter to
TRUE
.
addCapacity The setting to increase the storage size (capacity) of the
virtual disk for which you are defining properties. Size is
defined in units of bytes,
KB
,
MB
,
GB
, or
TB
. The default
value is
bytes
.
NOTE: A space must be added between the last digit
and the size (bytes, KB, MB, or GB) for values greater
than
9
.
addPhysicalDisks Adds new physical disks to the virtual disk. Specify the
enclosure ID and slot ID for each physical disk that you
assign to the virtual disk. Enclosure ID values are
0
to
99
.
Slot ID values are
0
to
31
. You must put brackets ([ ])
around the enclosure ID values and the slot ID values. Use
with the
addCapacity
parameter if you must specify
additional physical disks to accommodate the new size.
consistencyCheckEnabled Turns consistency checking during a media scan on or off.
To turn consistency checking on, set to
TRUE
. To turn
consistency checking off, set to
FALSE
.
189