Cumberland EDGE 890-00601, Installation And User Manual

Page: 70 / 258

Chapter 8: Equipment configuration
Max. Amp — Enter the maximum amperage if it differs from the proposed value
4. If desired, set the location of the stir fans by pressing on the localization button and roughly selecting
the location where the stir fans are located.
Once configuration is complete, the tile is green and displays the stir fan icon.
Configuring a water meter
1. Press on Water Meters in the list of equipment on the left hand side of the screen and then press on
the icon.
2. Enter the name of your choice or leave the default name.
NOTE: If the name chosen is too long, it is truncated on the tile.
3. Enter the volume per pulse, and select the unit of measure you prefer from the drop down list.
4. Select the enclosure, slot and input where the water meter is connected from the drop down lists.
The tile displays the water meter’s cumulated volume, but remains gray until it reads at least one pulse.
Testing a water meter configuration and input
1. After having configured a water meter and the cumulated volume is displayed, turn on the water
supply and open the flush valve.
2. Let the water flow for a minute, and then turn off the water supply.
The system having seen at least one pulse, the tile turns green and displays the water meter readings,
otherwise the tile turns orange.
Configuring a relative humidity sensor
1. Press on Humidity Probe in the list of equipment on the left hand side of the screen and then press
on the icon.
2. Enter the name of your choice or leave the default name.
NOTE: If the name chosen is too long, it is truncated on the tile.
3. Select the model from the drop down list.
4. Select the enclosure, slot (or module) and input where the relative humidity sensor is connected
from the drop down lists.
The tile is green and displays the relative humidity sensor reading.
70 895-00693 EDGE