Cumberland EDGE 890-00601, Installation And User Manual

Page: 58 / 258

Chapter 7: House/barn and room management
Brooder, fixed
temperature No No Yes
Brooder, offset
temperature No Yes Yes Follows house/barn T° set point
Brooder, curve
temperature No No Yes
Cool cell No No Yes
Mister/fogger Yes No Yes
Mister/dripper Yes No Yes
Water valve Yes No Yes
Soaker
Yes No Yes
Feed auger No No Yes
Feed actuator No No Yes
Using clean mode
Clean mode is used to interrupt regular operations of the controller when the house/barn is empty. When
this mode is enabled, the controller fully closes the tunnel curtain, adjusts the position of the air inlets, and
provides a minimum level of heat and ventilation set in the ventilation grid for proper CFM and tempera-
ture set point.
Setting minimum ventilation for clean mode
1. For the selected house/barn, press on the icon, and then press on the house/barn setup button
on the lower left hand corner.
2. Press on the Power ventilation menu, and set the required CFM in the Clean Mode section.
3. During general house/barn configuration, press in the box next to use clean mode to enable clean
mode for the selected house/barn.
Setting the target temperature for clean mode
1. For the selected house/barn, press on the icon, and then press on the house/barn setup button
on the lower left hand corner.
2. Press on the house/barn temperature setup menu.
3. Set the target temperature while operating in clean mode.
Setting alarm parameters for clean mode
1. For the selected house/barn, press on the icon, and then press on the alarm setup button on
the lower left hand corner.
2. Press on the house/barn temperature alarm menu.
58 895-00693 EDGE