Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 57 / 134

Replacing Air Supply Filters 43
Figure 23: Disconnecting air supply
Note: Disconnecting the compressed air will generate a lot of noise as the
air rapidly bleeds out of the output device.
Connecting the Compressed Air
After you replace air filters, you must reconnect the compressed air supply
before the output device can return to normal operation. Air pressure in
the output device should return to 80 psi.
To reconnect the compressed air supply:
1.
Grasp the spring-loaded collar of the compressed air hose.
2.
Push it firmly onto the compressed air inlet on the output device
.
Figure 24: Connecting air supply
WARNING: Failure to remove air pressure from the output device before
removing some or all of the air filters causes unfiltered air to be drawn into
sensitive areas of the output device. This eventually degrades performance
or damages the output device. Personal injury or damage to the output
device could also result.