Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 90 / 134

76 Chapter 4– Troubleshooting
Table 11: Error Category: Laser
Error Category: Laser
Error Message Recommended Operator Action
Cannot continue, laser is not
ready.
[Error #: 18017]
1.
In the Suspend dialog box on the workstation, click
the
Resume
button.
2.
If this message is displayed again, wait 30 seconds
and click the
Resume
button again.
3.
Repeat step 2 until the output device restarts.
When the Trendsetter has recovered from the error,
the message log on the workstation will display the
following message:
Laser is ready
One or both plate dimensions too
large.
[Error #: N/A]
To correct the error:
1.
Check the plate type information to ensure the
medium size stated on the workstation matches the
size you loaded.
2.
If the medium sizes match:
In the Suspend dialog box on the workstation, click the
Resume
button to resume imaging.
Or:
If the medium sizes don’t match:
Click the
Cancel Image
button in the Suspend dialog
box, and modify the media size as needed.
Or:
Load a different-sized medium into the output
device.