Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 68 / 134

54 Chapter 3 – Maintenance
.
Figure 31: Replacing the Mylar Strip
6.
Wrap the membrane around the suction cup side of the picker so it
covers the suction cups.
7.
Compress the foam block with one hand and snap the other end of
the membrane to the screw head.
8.
Check the alignment and tension of the mylar strip.
The strip should fit snugly against each suction cup. If it feels loose (for
example, if you can slide it from side to side), move the foam blocks
closer to the ends of the picker (see Figure 31). The holes in the strip
should align with the holes in the center of each suction cup.
Figure 32: Mylar Strip Alignment
Note: If you experience difficulty at any point in this procedure, please call
your service representative.
9.
Close the plate cover.
When the plate cover is closed, the picker moves back to the down
position. The machine beeps three times to indicate the end of
maintenance mode. The machine is ready to begin operation.
Attach membrane to
screw head
Foam block
Remove protective
coating
The mylar strip is
aligned with the
suction cups