Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 78 / 134

64 Chapter 4– Troubleshooting
Multiple plates on drum (or
head) out of alignment by
<error> microns.
[Error #: 15361]
The plate thickness measured by the output device is much
thicker than expected (i.e. specified in workstation
software). Sometimes two or more plates get stuck together.
To correct the error:
1.
Cancel the job.
The plate(s) will automatically unload.
2.
Separate the plates and stack them on the load table
again.
3.
Be sure that no other plates are likely to stick together.
4.
Resubmit your job and try again.
Plate still on unload table,
can’t unload.
[Error #: 15311]
The output device was unable to move the plate from the
unload table to the plate stacker or processor.
To correct the error:
1.
Ensure your plate stacker or processor is on and working
properly.
2.
Check whether the plate is stuck between the unload
table and the plate stacker or processor.
3.
Remove any stuck plates and feed them manually into the
plate stacker or processor.
4.
In the Suspend dialog box on the workstation, click the
Resume
button.
Error Category: Auto Loader (ALE)
Error Message Recommended Operator Action