Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 73 / 134

Error Messages and Recommended Solutions 59
Example of a Suspend Condition
Error Messages and Recommended Solutions
This section describes most of the error messages that display on the
workstation when problems occur with the Trendsetter. For each message,
the following information is provided:
•
the text of the error message (displayed on the workstation monitor)
•
the recommended action you should take to solve the problem
Plate
Removed
This indicates that you have manually intervened to fix a
problem, for example, you have manually removed a
misaligned plate. Click this button after you remove the
media.
Important: You must remove the medium before you click the
Plate Removed button.
Cancel
This option terminates the current operation, for
example, load, image, or unload. The output device will
unload the media, if currently loaded. Click this button to
terminate the operation.
Error Message Possible Operator Actions
Carriage: could not
find edge of plate
check that plate
size is entered
correctly.
•
Click the
Cancel Image
button to cancel
the image. The media is unloaded
without being imaged.
•
Click the
Resume
button to try to find
the media edge again.
The
Plate Removed
button is not available
for this suspend condition.
CAUTION : When correcting error conditions, do not open or remove output
device access panels more often than is absolutely necessary. Opening access
panels is unavoidable, but should be kept to a minimum to reduce the
accumulation of dust in and around sensitive components.