Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 44 / 134

30 Chapter 3 – Maintenance
Maintenance Schedule
Table 3 on page 30 outlines the maintenance required to achieve optimum
performance quality of the output device, and to decrease the number of
service calls you make. Failure to perform this maintenance can result not
only in poorer performance, but also can cause serious damage to your
output device. Keep records of when you perform maintenance on the
output device.
WARNING: Before performing any maintenance procedure, ensure that the
output device is not imaging a medium. The output device should then be shut
down.
Table 3: Schedule of recommended maintenance procedures
Location Description Maintenance
Procedure Clean Replace Every
Output device
exterior Clean exterior surfaces See page 32 Weekly N/A
Load table Load table See page 33 Weekly N/A
Manual bypass tray Manual bypass tray See page 33 Weekly N/A
Filters inside the
front access panel Check the filter bowls for
water or oil See page 42 Weekly When cracked
Debris removal
cabinet Vacuum interior of debris
removal cabinet Monthly
Edge detection
strip Edge detection strip on the
drum See page 37 Every 3
months N/A
Plate roller Rubber roller that holds
media to the drum during
media loading See page 39 Every
Month N/A
Filters inside the
front access panel • 5 µm filter
• 0.01 µm filter See page 44
See page 46 3 months
3 months
Filter inside the
right-end access
panel Intake pre-filter (2'
x
1'
x
2")
See page 48 N/A 3 months