Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 25 / 134

Supported Media 11
Media Orientation
Table 2 on page 11 identifies the appropriate orientation for each medium
size supported by the output device.
Table 2: Media Orientation Supported
Details on Portrait Orientation
Using portrait orientation can decrease imaging time. However, consider
the following before using portrait orientation:
•
The output device cannot image underneath the clamps so it’s
impossible to image to the edge of the medium.
•
The output device registers along the short side of the medium,
meaning you must punch on the long side. (To punch on the short
side, the plate must be cut perfectly square.)
Media Dimensions
The following media dimensions apply to the Trendsetter 3244+ AL. They
may not apply to media dimensions you define in other pressroom
operations, for example, putting a plate on a press.
Medium Size Orientation
Around the drum:
minimum 15.5" (394 mm), maximum 33" (838 mm)
Along the drum axis:
minimum 30" (762 mm), maximum 44" (1118 mm)
Landscape
Around the drum:
15.5" (394 mm)
Along the drum axis:
13.0" (330 mm)
Portrait
*
* In Manual Load/Unload Mode