Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 34 / 134

20 Chapter 2 – Operation
•
The Load light on the operator interface is lit. When this light is
flashing, you cannot open the operator door or the manual bypass
panel.
2.
Determine the size and type of media you need to load.
3.
Lift the operator door.
This door is supported by gas struts and slowly lifts itself upward.
Figure 7: Open operator door
4.
Wearing gloves, remove one or more plates from the packaging and
discard any packaging material that may be attached to the media.
Note: You may remove slip sheets from plates either before or after you
stack the plates on the load table.
CAUTION : You MUST ensure all slip sheets and packaging material have
been removed from both the back and front of the plates before you image
them in the output device. Otherwise, the thermal laser could ignite the
paper, causing a fire in the output device.
5.
Position the media on the load table.
Using the media alignment labels on the load table will help you
precisely position the plate stack.
Note: Ensure that the side of the plate to be imaged (the emulsion side) is
facing you. With plates, the emulsion side is usually the duller-looking
surface.