Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 50 / 134

36 Chapter 3 – Maintenance
Figure 19: Raised front access panel
CAUTION: Be careful not to bump your head on the raised panel!
To close the front access panel:
¾
Close the front panel and rotate both latches 90
º
clockwise (to the
horizontal position) to secure it.
Removing and Replacing the Right-end Access Panel
You must remove the right-end access panel to inspect and replace the air
pre-filter or the desiccant bag. There are two screws that secure this panel
to the output device.
To remove the right-end access panel:
1.
Use a flathead screwdriver to rotate both screws 90
º
counterclockwise
to release the panel.
2.
Tilt the panel back and carefully lift it off its locating pins to remove it.
To replace the right-end access panel:
1.
Rest the bottom of the panel on its locating pins.
2.
Tilt the panel forward towards the output device until it is upright.