Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 93 / 134

Error Messages and Recommended Solutions 79
Table 13: Error Category: Workstation Communications
Error Category: Workstation Communications
Error Message Recommended Operator Action
Door is open.
[Error #: 3017]
An output device access panel is either open or has been
removed. The output device cannot image media when a panel
is opened or removed.
To correct the error:
1.
Close or replace all output device access panels.
Emergency Stop [Abort]
switch on.
[Error #: 3019]
The Emergency Stop switch on the output device has
accidentally been pushed. The output device cannot image
media while the Emergency Stop switch is activated.
To correct the error:
1.
Reset the Emergency Stop switch to continue operations.
Resolution does not exist.
[Error #: 3047]
This error message can occur routinely when you start the
workstation. You can safely ignore this message.
Image too wide for plate.
[Error #: 3048]
1.
Ensure the medium size loaded is the size defined in the file
you sent to the output device to be imaged.
2.
If the medium size is correct, the error could be a problem
with the workstation software or the PostScript file.
Or:
If the medium size is incorrect, click the
Cancel Image
button
in the Suspend dialog box, and modify the medium size as
needed.
3.
Record the medium separation color(s) that had the error.
4.
Call your service representative to report the error.