Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 33 / 134

Shutting Down the Trendsetter 3244+ AL 19
Shutting Down the Trendsetter 3244+ AL
The workstation is normally left running at all times. If you want to turn it
off, however, see your workstation or Intel documentation for
instructions.
For information about exiting the workstation software, see the
workstation software documentation.
CAUTION: Ensure the media has been removed from the output device before
you shut it down.
To shut down the output device:
¾
Turn the output device off using the power switch.
See Figure 6 on page 18.
Automatic Operation
For automatic operation, you can load:
•
up to 80 0.15 mm/0.006" plates
•
up to 40 0.3 mm/0.12" plates
Note: Remove all slip sheets either before or after you place the media on the
load table.
You can submit the files you want to image either before or after you place
the media on the load table. For details on submitting files, see your
workstation software documentation.
CAUTION: P late edges can be sharp. Failure to wear protective gloves can
result in personal injury.
To load multiple plates for automatic operation:
1.
Ensure the output device is ready to accept the media for imaging.
This means:
•
A workstation message is displayed, telling you which size and type
of media to load.
Note: If you have not yet submitted the files you want to image, the
message will not be displayed.