Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 82 / 134

68 Chapter 4– Troubleshooting
Timeout waiting for load
button to pressed.
[Error #: 15250]
A manual bypass job had been started but the Start button
was not pressed within the two-minute timeout period.
To correct the error:
1.
In the Suspend dialog box on the workstation, click the
Resume
button.
2.
Place the plate on the manual bypass tray.
3.
Press the Start button on the operator interface.
Unload carriage not in safe
position to rotate cups.
[Error #: 15306]
The unload table traveller was not able to find the rotate
position. The plate may have become stuck in the clamps,
causing the traveller to lose steps and not reach the rotate
position.
To correct the error:
1.
In the Suspend dialog box on the workstation, click the
Resume
button.
2.
When the plate is unloaded, check it for damage.
3.
Resubmit the job and try again.
Error Category: Auto Loader (ALE)
Error Message Recommended Operator Action