Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 83 / 134

Error Messages and Recommended Solutions 69
Table 7: Error Category: Carriage
Error Category: Carriage
Error Message Recommended Operator Action
Could not find edge of
plate.
Check that plate size is
entered correctly.
[Error #: 7011]
1.
Ensure the medium was loaded with the side to be imaged
(the emulsion side) facing up.
2.
Make sure the medium was loaded in the correct position on
the load ramp.
3.
Determine whether the medium you loaded was the correct
size.
4.
If the medium is the correct size, try loading it again.
Important: If the error persists, contact your service representative.
Limit switches reporting
carriage is both HOME
and AWAY.
[Error #: 7000]
1.
Open the top and front access panels of the output device.
2.
Check to see if there is a slip sheet, a medium, or debris stuck
around the exposure head inside the output device.
3.
Remove any material and try to image the medium again.
Or:
If there is no foreign material present, write down the error
message, and call your service representative.
Stuck in AWAY position.
[Error #: 7002]
1.
In the Suspend dialog box on the workstation, click the
Resume
button.
2.
If the workstation reports the error again, click the
Cancel
Image
button in the Suspend dialog box.
3.
Reboot the workstation.
4.
Shut down the output device.
5.
Start the output device.
6.
Start the workstation software.
The error may go away temporarily.
7.
Call your service representative to report the error.
Important: Your Trendsetter may need servicing.