![background image](http://html1.mh-extra.com/html/cpi/indico-100-series/indico-100-series_service-and-installation-manual_2675023231.webp)
CPI Canada Inc
Troubleshooting
5
Millenia / Indico 100 Series Service Manual Ch # 740904-09 Rev. B
Page 5-3
5.2.2 Limit
Messages
(Cont)
GEN DUTY WARNING
The generator has exceeded its duty cycle
warning limit.
Re-evaluate technique
factors. Allow
generator to cool if
possible. If exposures
are continued, serious
generator damage
may result due to
overheating.
5.2.3 Error
Messages
These messages indicate that an error has occurred. The errors are logged in the error log, previous errors
should be reviewed by service personnel before taking further action.
ERROR CODE
MESSAGE
PROBLEM
ACTION
E001
GEN EPROM ERR
Generator CPU EPROM has
been corrupted.
Call product support
for new generator
CPU EPROM.
E003
GEN NVRAM ERR
Generator CPU NVRAM
data has been corrupted.
Re-initialize
generator CPU
NVRAM using
generator factory
defaults.
E004
GEN RTC ERROR
Generator CPU real time
clock is not functioning.
Reset time and date.
E005
PS CONTACT ERR
Main contactor in HF power
supply did not energize.
Call product support.
E006 ROTOR
FAULT 1.
Rotor
starter
may
have
detected a current fault in
the stator.
2. Power supply was not
ready to start rotor.
Power unit off and
retry rotor start.
E007
FILAMENT FAULT
Power supply has detected
filament current <2 amps.
1. Check for open
filament in X-ray
tube.
2. Check for poor
connections in the
cathode cable.
3. Check fuses on
filament board(s).