![background image](http://html1.mh-extra.com/html/cpi/indico-100-series/indico-100-series_service-and-installation-manual_2675023104.webp)
3B
System Interfacing
CPI Canada Inc.
Page 3B-4
Rev. E Indico 100 Series Service Manual Ch # 740895-05
3B.2.2 Low Speed/Dual Speed Starter
Refer to chapter 2 (installation) for instructions on wiring to the low speed or dual speed starter terminal
blocks. Note that the X-ray tube thermal switches may be connected at the starter terminal blocks, or at the
room interface board. Both sets of terminals are connected in parallel, and either may be used.
3B.2.3 High Tension Transformer
Accepts the high tension cables from either one or two x-ray tubes.
3B.2.4 Generator Interface Board
The generator interface board accepts the following (ABS only on R&F generators):
•
ABS - composite video (J8).
•
ABS - proportional DC (J7).
(Jumpers must be configured for different ABS types, refer to chapter 3E).
•
Control console (J4).
3B.2.5 Generator CPU Board
The generator CPU board accepts the following (all are optional):
•
Remote fluoro controller (J11).
•
RS 232 Port (J1).
•
RS 232 Port (J2).
3B.2.6 AEC Board
Depending on the Indico 100 generator’s configuration, different AEC boards may be fitted. Refer to chapter
3D:
3B.2.7 Console CPU Board
The optional hand switch connects to the console CPU board, refer to chapter 2 for details. If it is desired to
connect a remote fluoro footswitch (normally customer supplied), connect to TB6 pins 5 & 6 on the room
interface board, or optionally to terminals “F” and “COM” on TB1 on the console CPU board (23 X 56 cm
consoles), or to pins 7 & 9 of J13 on the 31 X 42 cm console. Refer to chapter 2.
3B.2.8 I/0 Expansion Board (optional)
This optional I/0 board will be used when the Indico 100 generator is interfaced with digital systems, film
changers and various dedicated products. A separate supplement will be included in the manual for this
board, if fitted.