![background image](http://html1.mh-extra.com/html/cpi/indico-100-series/indico-100-series_service-and-installation-manual_2675023190.webp)
3E
ABS Calibration
CPI Canada Inc.
Page 3E-12
Rev. D Millenia / Indico 100 Series Service Manual Ch # 740904-07
3E.3.1 Dose Limits (Cont)
* GENERATOR SETUP *
UTILITY
APR EDITOR: DISABLED
GEN CONFIGURATION
DATA LINK
EXIT SETUP
* GEN CONFIGURATION *
TUBE SELECTION
AEC SETUP
GENERATOR LIMITS
AEC CALIBRATION
RECEPTOR SETUP
FLUORO SETUP
I/O CONFIGURATION
TUBE CALIBRATION
EXIT
TUBE1 0%HU FLUORO SETUP* MAG:0
DOSE LIMITS
I/I MODES: 2
ABS SETUP
FL-RAD KV XFER: 6
MIN FLUORO KV: 50
+
-
EXIT >> DOSE:0
TUBE1 0%HU *ABS SETUP* MAG:0
LOOP GAIN 60
AUTO MA/KV CURVE: 0
NOMINAL DOSE 80
ABS CHANNEL: 5
DOSE 1: 100
+
DOSE 2: 100
-
<< DOSE:0
Use these steps to set the DOSE LIMITS.
Step Action
1.
Set up the radiation probe as per figure 3E-5 in the position indicated Max. Patient
Input Dose. Refer to the note on page 10 re focal spot to radiation probe distance. No
absorber is required at this point in the setup.
2.
Temporarily unplug the ABS pickup at J7 or J8 of the generator interface board.
3.
Temporarily de-energize the I.I. power supply, or cover the I.I. with approximately 1/16
″
(1.6 mm) lead.
4.
Enter into the generator programming mode. Refer to chapter 3C, section 3C.1.1.
5.
From the GENERATOR SETUP menu select GEN CONFIGURATION.
6.
From the GEN CONFIGURATION menu select FLUORO SETUP.
7.
Select ABS SETUP. Select AUTO MA/KV CURVE, then use the + or - buttons to
select auto mA/kV curve 1.
8.
Select << to return to the FLUORO SETUP menu.