Configuring Transport Stream Information
207
Configuring Transport Stream Information
Configuring the ASI Output
1
From the user interface of the D9824, choose
Transport Stream
>
ASI Output
.
The ASI Output page is displayed.
Note:
After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply
to save and apply the changes.
Note:
Any changes made to the ASI DPM values will automatically change the
Mode Status
to
Edited by User
.
2
Choose the output rate control from the
Rate Control
drop-down list. The
following table describes the affect each of the settings has on the output bit rate:
Summary of Contents for D9824
