Cisco D9824, Installation And Configuration Manual

Page: 126 / 416

Chapter 4 Front Panel Operation
104
Menu Item Description Parameters
Output Mode Select the DPM output mode
for the current output.
With the exception of
No
Output and Full DPM Control ,
selecting a mode will configure
the DPM settings to achieve the
specified behavior. In this way,
they act as DPM presets.
The
Config Type is changed
from Unmodified to Edited by
User .
We highly recommend that you
use either one of these basic
modes, or, for advanced setup,
enter the DPM mapping before
setting the
Output Mode .
No Output - No ASI output will be generated
and the ASI port will be disabled.
Passthrough - All PEs will be set to Pass and
other DPM settings will also be set.
Service Chans Only - This is similar to
Passthrough, except that only channels
applied to program entries are available on
the output.
MAP Passthrough - The output will be
identical to the input, except that channels
assigned to PEs and PIDs will be mapped
using the DPM settings. If the input is tuned
to a valid channel, the PEs are automatically
set to Map. Otherwise, the PEs are
automatically set to Drop. When selecting
MAP Passthrough, the option to re-sync will
be provided. If you select Yes , it will set the
DPM mapping to the last valid (or saved)
configuration. If you select No , it will use the
existing DPM maps. If the PE is mapped, it
uses the last saved output MAP
configuration. The output map (for example,
output channel PMT) does not change
automatically if the input or channel number
is changed.
MAP Svc Chans Only - This is similar to
MAP Passthrough, except that only channels
applied to program entries are available on
the output. If the input is tuned to a valid
channel, the PEs are automatically set to
Map. Otherwise, the PEs are automatically
set to Drop. When selecting MAP Svc Chans
Only, the option to re-sync will be provided.
If you select Yes , it will set the DPM mapping
to match the current input. If you select No , it
will use the existing DPM maps. If the PE is
mapped, it uses the last valid input. The
output map (for example, output channel
PMT) does not change automatically if the
input or channel number is changed.
Full DPM Control - The output will be
generated according to the DPM settings.
This is a manual control setting.