Cisco D9824, Installation And Configuration Manual

Page: 237 / 416

Configuring Transport Stream Information
215
12 From the Category drop-down list, choose the category or service to configure. If
an input service matches this type and Instance, then the Action will be applied.
This value is only used if the Action is set to Map. The categories are: UNKN,
CDT, LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID, PCR or INVL.
13 In the Instance field , enter the instance (1 to 64) of the service specified by
Category to configure. If an input service matches this type and instance, then
the Action will be applied.
14 If Action is set to Map , enter the Output PID number (0 to 8192) in the Output
PID field.
15 Click Save .
16 Click OK .
To remove a PID mapping, click the radio button of the entry you want to
remove and click Delete .
Synchronizing the Inputs
1 In the DPM Program Entry Setup table, each PE output can be synchronized to
its input according to one of the four output modes. Select the program entry
you want to synchronize and then click Resynchronize or click Resynchronize
All to synchronize the inputs to the outputs according to the service assignments
only. The Confirm Resynchronization window is displayed.
2 Select whether you want to synchronize the PE output according to the services
and then the PIDs assigned to each service, services only, PIDs only, or to
synchronize using a template.
Map Mode Description
Resynchronize Program, PMT
PID, ES List & ES PIDs The receiver will synchronize the PE output according to
the services and then the PIDs assigned to each service.
Resynchronize ES List The receiver will synchronize the PE output according to
the available input services only, and ignore the input to
output service PID mapping.
Resynchronize ES PIDs The receiver will synchronize the PE output according to
the input PIDs only, and ignore the service assignment
categories/names.