Cisco D9824, Installation And Configuration Manual

Page: 247 / 416

Configuring Transport Stream Information
225
Note: If FEC Mode is set to None , the FEC Scheme is ignored. For more
information on the FEC Mode , see Configuring Forward Error Correction
Settings (on page 230).
FEC Scheme Description
Block Aligned Column FEC packets are set by using an interleaver.
Non-Block Aligned Each FEC packet receives L packets after the last related data
packet.
11 Click Apply .
Setting Up the MPEG over IP Auto Synchronization Options
The MoIP Auto Sync section allows you to configure the DPM without editing each
output channel and PID separately.
1 In the MPEG over IP Output page ( Transport Stream > MPEG over IP Output ),
refer to the MoIP Auto Sync section.
2 From the Enable Auto Fix for Collision drop-down list, choose Yes for the DPM
to resolve channel and PID collisions automatically on the transport outputs.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click
Apply to accept
the new changes.
Choose
No and a detailed list of all the conflicts is displayed in the Output
Channel and PID Conflicts table (click View Conflicts ) when a conflict occurs.
You can then resolve the conflicts manually.