Cisco D9824, Installation And Configuration Manual

Page: 341 / 416

319
Alarm Message
Type Message Cause/Remedy Description Severity ID
FPGA status Set FPGA Done failed
to go high Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set SW ver outside
upper or lower
limit
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA ID does not
match FPGA
DESIGNATION
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA ID does not
match HW FPGA
ID
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Clear FPGA loaded
successfully and
reset
– – Major 39000
MPoIP Engine
Failure Set Critical MPoIP
engine failure, all
active streams
must be restarted
Cause: MPEG over
IP engine failure.
Remedy: Restart
all the streams.
Indicates that
MPoIP delay
FIFO is
overflowing.
This is a critical
error.
Major 92200
MPoIP Engine
Failure Clear Error cleared – – Major 92200