Cisco D9824, Installation And Configuration Manual

Page: 336 / 416

Chapter 6 Service and Maintenance
314
Alarm Message
Type Message Cause/Remedy Description Severity ID
FPGA
Temperature
Alarm
Set Temperature over
Alarm threshold Cause: Room
temperature too
high, or air flow is
blocked.
Remedy: Check
openings on front
and rear panels for
blockage. Lower
room temperature
or improve air
flow to device.
FPGA
temperature is
above safe
operating
range.
Major 30000
FPGA
Temperature
Alarm
Clear Temperature
normal – – Major 30000
ASI Out Status Set ASI Overflow.
Output Muted.
Reduce content.
Cause: Uplink
settings may have
changed since
setup of the unit.
Variable Bit
Rate/Statmuxed
streams may be in
use.
Remedy: Increase
the output rate,
drop unreferenced
content in DPM
Options, and/or
drop programs
not needed for
downstream
devices. Contact
your (uplink)
service provider to
verify the
expected bit rate
settings.
Current
transport rate
exceeds
configured rate
for ASI output.
Output has
been muted to
protect
downstream
devices.
Minor 34000
ASI Out Status Clear ASI Output
Restored – – Minor 34000